(904) 913-9111

New Well Drilling in Palatka, FL

New well drilling is how we put water on a Palatka lot that has none, or replace a well that has given out. We pick the spot, file the permit, drill to the aquifer, set the pump and pressure tank, and run the line to the house.

Licensed and insured, with a one-year warranty on our work. Free estimates on new wells.

A finished new water well: steel casing and cap in a lawn with the water line attached

How we drill a new well

  1. 1

    Walk the lot

    We look at where the house, the driveway and the septic system are or will be, and pick a spot that keeps the right distance from all of them.

  2. 2

    File the permit

    We apply for the well construction permit and wait for it. No permit, no drilling.

  3. 3

    Drill and case

    Our rig drills down through the sand and clay. We set the casing into the limestone and grout it in place.

  4. 4

    Develop the well

    We pump the new well until the water runs clear of drilling mud and fine sand.

  5. 5

    Pump, tank and line

    We set the submersible pump, the pressure tank and the pressure switch, and run the buried line to the house.

  6. 6

    Start it up

    We bring the system up to pressure, check every connection and walk you through the shutoffs.

What we build under your yard

Every part of a new well has a job. Tap a step to see it.

What we build under your yard Sand Clay Limestone aquifer Casing Submersible pump Line to the pressure tank
  • Sand and surface soil
  • Clay layer
  • Limestone aquifer
  • Water moving to the pump

Picking the right spot on your lot

Where a well goes matters as much as how deep it goes. Florida rules keep a private drinking water well at least 75 feet from a septic tank and drainfield, so on a smaller lot we plan the two together. We also keep the wellhead out of low spots where rainwater pools, and somewhere our truck can reach again when the pump needs service years from now.

If you are building, call us before the slab goes in. Moving a well on paper is free. Moving it after the septic system is installed is not.

Every new well we drill includes

No surprise add-ons at the end. This is what a finished job looks like.

  • The well construction permit, filed and approved before we drill
  • Casing grouted from the limestone back to the surface
  • A submersible pump matched to the well and the house
  • A pressure tank and pressure switch set and adjusted
  • The buried water line to the house
  • A start-up check with you on site, and a one-year warranty on our work

New well questions

How long does it take to drill a well?

The drilling itself usually takes a day or two once the permit is in hand. Permit review is the part we cannot rush, so we file it as soon as you say go.

Will the water smell like sulfur?

Some Floridan aquifer water around Palatka carries hydrogen sulfide, which gives it that rotten egg smell. We will tell you what wells near you are like before we drill, and you can have the new well tested once it is running.

Can I drill a well if I am on city water?

Often yes, especially for irrigation, but it still needs a permit. Call us with the address and we will check what applies.

What happens to my old well?

An old well you are not going to use has to be properly plugged by a licensed water well contractor under a permit. We can quote that at the same time as the new one.

More on wells from our Palatka crew

Ready for a new well?

Call or text (904) 913-9111 for a free estimate. We handle the permit from there.

Call (904) 913-9111

Monday to Friday, 8 a.m. to 6 p.m. After-hours calls answered.

Call nowContact us